
Maintenance Specs for Suzuki GD110

Fuel type : Use gasoline with an octane number of 90-97 unleaded.
Engine oil Change : 900 ml
Note: If you're replacing both the engine oil and the oil filter element, start by pouring 1 liter of engine oil into the engine. This ensures proper lubrication and smooth operation. Similarly, if only the engine oil is being changed without replacing the oil filter element, still pour 1 liter of engine oil into the engine to maintain adequate lubrication.
1100ml After overhauling engine:
Recommended Engine oil API Standard: API SG, M A
Oil Change Interval : 2000 - 3000 km or earlier ( depends on riding conditions and engine oil type )
​​
Standard : NGK CR6HSA
Cold type : NGK CR7HSA
Hot type : NGK CR5HSA
note: cold-type spark plug in summer to prevent engine overheating and detonation and Use hot-type spark plug in winter to prevent spark plug fouling.
Spark plug Gap : 0.6 mm - 0.7 mm
Spark Plug Tightening : 1/2 or 180° for new spark plug and 1/8 or 45° turn for used spark plug
​
Valve Clearance : 0.03 - 0.08 mm ( inlet ) - 0.08 - 0.13 mm ( exhaust )
Check Vlave Clearance Every : 2000 - 3000km
Note: Adjust Valve Clearance on cold engine
​
Engine idle speed : 1500 Rpm ± 100 Rpm
​
Battery : 12 V , 5 A
Fuse : 15A
​
Clutch lever FreePlay : 10 mm - 20 mm
Front Brake Lever FreePlay : 10 mm - 20 mm
Rear Brake Pedal Free Travel : 20 mm - 30 mm
Height of the rear brake pedal: 8mm
Rear Brake Pedal Free Travel: 20-30mm
​
Chain Slack : 10 mm - 20 mm
Lubricate Chain With: SAE 90 oil
Chain Lubrication Iterval : 500 km or less
​
Front Axle nut Torque Specs : 3.6 - 5.2 k.gf - m ( 26 - 37 Foot Pound )
Rear Axle nut Torque Specs : 3.5 - 5.5 k.gf - m ( 26 - 39 Foot Pound )
Sprocket Carrier Nut Torque Specs : 3.5 - 4.5 k.gf - m
Front Tyre Pressure : 29 Psi with Rider and Passenger
Rear Tyre Pressure : 29 Psi For only rider , 32 Psi with Rider
+ Passenger
​
Front shock absorber oil
capacity (each leg) : 106ml
Fork Spring Service Limit : 426.3 mm